Logixpro elevator simulation3/13/2024 ![]() ![]() Once level 2 sensor IP1 energises, the elevator doors can then open via OP2. The elevator should then move up to level 2 via OP0. The elevator doors would then close (OP3) energising IP5 (doors closed sensor). The elevator could also be operated from level 1 via the internal button IP3. After a short pause the elevator doors should open via OP2. Once the elevator reaches level 2, IP1 would energise and this should stop the elevator motor. ![]() At this point the elevator should start to move up via OP0 (elevator motor UP). The elevator doors should then close via OP3, once closed IP5 (doors closed sensor) should energise. ![]() The elevator could be called from level 2 by the external call button IP0 being pressed. Level 1, (IP2 energised), there are two options The operation of the elevator is as follows: Assuming that the elevator is at I am pretty new at this and I am quite baffled with this new problem of mine. Hello everyone, thank you in advance for taking the time to read this post. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |